How to - Raise the front on a Mk1 pajero

Tools needed.

2 x 17mm spanners
1 x 17mm socket and ratchet
1 x wire brush
1 x wd40
1 x cup of tea

Time 30 min max.

you dont need to jack the jeep up, unless your carrying a keg. :lol:

First thing is boil the kettle.

proceed to your jeep and locate the torsion bar mounts located just behind the doors.

http://i141.photobucket.com/albums/r...t/P4200026.jpg

next step is spray wd40 on the two nuts on top and clean witha wire brush.

http://i141.photobucket.com/albums/r...t/P4190015.jpg

http://i141.photobucket.com/albums/r...t/P4190019.jpg

re spray wd40 through the hole in the crossmember, (make sure your down wind) :shock:

next step is complicated and varys alot

milk/no milk, No sugar/how many spoons.
enjoy first mouthfull of tea.

next you loosen the top nut whilst holding the bottom of the two.

http://i141.photobucket.com/albums/r...t/P4190020.jpg

http://i141.photobucket.com/albums/r...t/P4190021.jpg.

Now hold the lower nut with the spanner and put your ratchet on the bolt and turn clockwise to raise it.

i could only raise it 3/4" and ran out of thread

tighten the top nut down ontop of them bottom nut. and viola job is almost done.

here's the bumpstops that youe might have to trim but i dont fo some reason :?

http://i141.photobucket.com/albums/r...t/P4200025.jpg

difference before and after a drive over some stuff to settle the suspension.

http://i141.photobucket.com/albums/r...t/P4190013.jpg

http://i141.photobucket.com/albums/r...t/P4190023.jpg